1/13/2024 0 Comments Floating bed frame king![]() I noticed all the wireless options had mixed reviews. This is where I will place the LED strip.Īfter researching online trying to find low profile puck lights. I then attached the strips of lumber to the back of the headboard. ![]() ![]() I sanded between each coat with 400-grit sand paper. Be sure to add a stop to the drill bit to prevent going all the way though.Īppy whip on polyurethane or a top coat of your choice. Then, install threaded inserts into the in the back of the nightstand. Now, remove the nightstand and drill out a 1/4-inch hole for the bolts to pass through. Repeat this process for the other nightstand. While the nightstand is still mounted with the clamps, trace out the hole for the electric box on to the headboard, drill a hole for the small on/off switch, and drill an angled hole at the bottom into the headboard for the puck light. To clarify, the pilot hole should not exit out the nightstand (this should only mark the back). Next, drill four pilot holes from the back of the headboard. I chose to mount them approximately 2 inches below the top of the mattress. Whichever route you take, just be sure to use wood glue and clamps.Īfter allowing enough time for the glue to dry, clamps the nightstand at the desired mounting height. The next option is to use screws and fill the heads in with wood filler. You have to be patient with dowels - a fraction off could cause your workpiece to shift, which could be very frustrating. I used a dowel jig from Rockler to make accurate holes for the dowel pins. Then I cut out the opening for the electrical work box. After identifying which piece looked less attractive I selected it to be the back of the nightstand. It made sense to add outlets in the nightstands. With the headboard being so massive, it covered the existing wall receptacles.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |